Clarity INT9 A/D Guide de l'utilisateur télécharger pdf (Page 48)

Clarity - Getting Started Connecting Autosamplers

Any autosampler that is used in the Clarity

Active Sequence without

an AS Control module

must be synchronized with the Clarity station by

cables. The IN

starting cable should be plugged

into the synchronization output (INJECTION)

of an autosampler and the OUT

R cable

plugged into the synchronization input

(READY) of an autosampler.

Note: Further information about Active Sequence is

available in the Clarity User Guide.

AUTOSAMPLER

INJECTION

READY

OUTPUT

INT 7

(U-PAD, INT 5)

Autosampler wiring in LC set

for Active Sequence

without using the AS Control module.

Starting cable -

Digital Output -

OUT

DETECTOR

PUMP GRADIENT

OUTPUT 3

OUTPUT 2

START

Fig. 19. Wiring of an autosampler in an LC set

Note: The labels on the input and output contacts may

vary depending on the type of the autosampler.

When using additional devices (Detectors, LC

Pumps, etc.) it is recommended to connect

these devices independently

to other digital

outputs of the A/D board. Each device will

then need a dedicated row in the Event table

to be started or stopped.

Note: When the detector or pump start inputs are

connected in paralel to the Clarity start input,

problems are often encountered due to instrument

grounding.

6.1.3 AS - Passive Sequence (GC or LC)

The autosampler used in the Clarity Passive

Sequence (both GC and LC sets) does not

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Clarity INT9 A/D Guide de l'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Clarity INT9 A/D